Skip to content
yymaxx.ing / reef
Back to the reef

How I'm planning to move seawater across the office

The toilet is far from the aquarium, so I worked out an RO/DI, jerrycan, ATO and water-change routine that doesn't involve carrying huge buckets of saltwater every week.

A small reef aquarium photographed by Martin Guerre

Photo: Martin Guerre · CC0

The office toilet is quite far from where the reef is going, and my first thought was: water changes are going to be so annoying. With my freshwater tanks, the more annoying a chore was, the longer I put it off. So this time I gotta be way more disciplined.

There's a wall-mounted tap in the toilet, including a threaded one that might fit the RO/DI unit I ordered. I make the clean water there, the reject water goes down the drain, and I carry only what I need back to the tank.

The jerrycan saga

I first ordered a 25 L black jerrycan. The seller sent a white one instead which doesn't fit the look of the office (ewww), and so I got a full refund and still got to keep it. Stonks! That one will be for non-tank stuff, like hauling wastewater for cleaning.

For the reef I bought a new 20 L container with a bottom tap and screw cap, S$23.63 on Shopee. 20 L is plenty for the small water changes I have in mind, and the tap means I can pour without lifting and tipping a full container.

It doubles as my auto top-off reservoir. My ATO pump pulls water up through a tube instead of sitting at the bottom of the container, so I just run the tube through the cap and leave a gap for air as the level drops. The tap stays free for pouring fresh RO/DI by hand.

This matters more than it sounds. As I found out when working out evaporation, water evaporates from a saltwater tank but the salt stays behind, so the tank slowly gets saltier. The ATO replaces what's lost with plain RO/DI, automatically.

Regular water changes

Once there are animals in it, I'm thinking of starting with about 7-8 L per water change, roughly 10% of the tank's estimated working volume. Take RO/DI from the jerrycan, mix a fresh batch with Red Sea Salt in a clean basin, check it with the refractometer, siphon the old water into a separate bucket and top up with the new. The saltwater for changes and the fresh water for the ATO never mix.

The first big fill will be a few trips back and forth, and that's fine since it only happens once! And I'll be excited to do it too I know it.

xo, yy


Some links in this article are affiliate links. I may earn a commission if you buy through them.