Skip to content
yymaxx.ing / reef
Back to the reef

I have a whole reef tank ready, but nowhere to put it

The metal rack sagged, the standing desk might not be safe, and now I'm wondering if a thick sheet of plywood can save the rack I already own.

A small reef aquarium photographed by Martin Guerre

Photo: Martin Guerre · CC0

Plot twist: the hardest part of this reef so far isn't the corals or the water chemistry. It's finding something to put the tank on.

If you missed the shop hopping post, I bought a metal storage rack to use as the stand. 100 × 40 cm, fits the office corner perfectly, and the seller says it holds about 100 kg per shelf. Then I put the empty 90 × 30 × 30 cm tank on it with about 25 kg of sandbags and watched the shelf start to sag... So now we need a new plan. Once there's glass, rock, sand and water in it, the finished tank will be close to 100 kg, so who knows how it'll fail.

The standing desk plan

The backup was a standing desk collab. Raise the tank up to look at it, lower it down for water changes, which I thought was a pretty fun use for a standing desk. The brand raised a fair point though: a desk can have a high total weight rating, but it's also about the weight distribution on the desk, so it might be possibly dangerous - after all, no one has proposed such an outlandish idea before.

Maybe the rack isn't the problem

Before giving up and buying a proper aquarium stand, I took a closer look at the rack that I already had. The seller confirmed the 100 kg is per shelf, and it's a three-tier rack, so the frame should be built to carry a lot more than one shelf's worth. It's just the thin removable metal panel that was flexing and stressing me out.

So what if I lay a thick sheet of plywood over it? The board would spread the weight onto the steel frame directly. Down the rabbit hole I went, comparing plywood thicknesses and how much a board sags when it's supported on all four sides - don't understand the math that ChatGPT was doing, but it made sense, a thicker, better quality plywood board will support a tank better, but we need to remember the weight of the board counts too. The one I'm hoping to find now is 25 mm, cut to fit the rack and finished in PVC so splashes don't get into the wood.

The problem is nobody actually knows what limits the rack to 100 kg. If it's the panel, the plywood would solve that problem. If it's the beams or the joints, then we'll be f\\ked if we exceed the weight limit. So either way, 100kg is a hard limit for the rack.

i just want to get this going asap man....

xo, yy